Oberkorn mk3 user manual

A quick note about analogue sequencers: Analogue sequencers are devices that allow a sequence up to 16 steps in the case of Oberkorn of voltages and gate signals to be 'played back' sequentially in order from 1 to Each step has its own control to vary Voltage and a switch to turn the Gate on or off for that step. As the sequencer advances through each step, the CV and Gate signals for that step are output at the CV and Gate sockets.

When step 16 is reached, the sequencer resets to step 1 and starts all over again. Oberkorn has 3 CV and 2 Gate channels, 16 steps, and can be made to step in any order. Control Voltage CV is normally used to control an oscillator's pitch, but can be used to control any module that has a CV input, such as filter cut-off.

The Gate signal is usually used to trigger an envelope, but can be used to control any module with a gate, trigger or clock input. There are many controls and features on an analogue sequencer to give more overall control over the way the sequencer opperates. Software sequencers do not offer this advantage, and very very few hardware MIDI sequencers do either. The voltage rang of each Cv row can be adjusted using 48 knobs. All rows can be shift tranposed in real time, and a glide voltage slew can be added to first 2 row.

These all run in parallel. Bothcan be on or off, they can be both on together too. Internal clock, external clock or use a special legato mode. Midi to clock function, trigger and step number converter. Synth, drums, fx Write us report Error Contribute Support Us. Analogue Solutions Oberkorn. Sequencer Data based on latest version Mk3".

Main Data.